Published in Graphics

Inno3D enters 3D printer space with two products

by on05 October 2014



Going physical

Nvidia AIB partner Inno3D is entering the 3D printer space with the launch of two mid-range consumer printers.

AIBs have seen better days and in recent years many have started to diversify and enter new niches, ranging from various gaming peripherals, through tablets to gaming PCs and small form factor computers.

To the best of our knowledge, Inno3D is the first AIB partner to branch out into 3D printing.


Inno3D's first 3D printer


So far the company has two mid-range fused filament fabrication (FFF) 3D printers priced north of €1,000. Both appear to share the same internals.

The Inno3D Printer M1 comes in a fully enclosed chassis, measuring 49cm (width) x 43cm (depth) x 59cm (height). The actual build volume is 140mm (L) x 140mm(W) x 150mm (H) and the printer weighs 11kg.

inno3d-printerm1x

 

The M1 features a single 0.3mm nozzle and it uses standard 1.75mm filament. The printer can use PLA, ABS and Nylon filament. Layer thickness ranges from 0.10mm to 0.25mm. It has a touchscreen user interface and a keypad and it ships with free 3D printing software with STL to printer file format conversion. It can be hooked up via USB 2.0, but it can also use SD memory cards.


Inno3D Printer D1 features an open bed design


The Printer D1 uses virtually the same hardware platform, but it has a completely different design. It is not enclosed and the metal chassis looks quite a bit more rugged, making it somewhat more suitable for small businesses and other organisations that would use it on a daily basis.

inno3d-printerd1

 

The spec appears to be identical, it has the same layer thickness and it uses the same nozzle. The press photos show a significantly bigger filament spool, but at this point we cannot confirm whether it can support bigger spools than the M1 or not, since it is possible that the M1 can handle the same spool.

We found both printers listed in Europe at about €1,150, here and here, but we could not find them listed on Inno3D's site, despite the fact that the M1 was announced a couple of weeks ago. 3Diot managed to find the M1 spec sheet, but we were unable to find more info on the D1.


Last modified on 05 October 2014
Rate this item
(0 votes)

Read more about: